- Approximately 8 hours are needed for a complete charger of the
battery. Never attempt to overcharge the battery (although it is
recommended that the rst charge of the battery be of 16 hours in
duration).
- When the battery is charged disconnect the charger from the
mains supply.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that all products’ packaging has been removed.
- Before using this product for the rst time, it is important to make
a full charge of batteries.
- This appliance has not been designed to work connected to the
mains, only to batteries.
INSERTION OF A COMB GUIDE:
- Take the guide comb and insert it into the guides (Fig.1).
- To remove the guide comb, hold the comb measurement selector
low, and then pull the comb upwards. (Fig 2.)
USE:
- Make sure that the blades are correctly aligned.
- Turn the appliance on, by using the on/off button.
- Select the desired cutting height using the comb height selector
(F). Press it and adjust the height according to the desired cutting
length.
HOW TO CUT THE HAIR:
- Situate the person whose hair you are going to cut so that the top
of their head is at your eye level. Place a protective towel or cloth
around their neck.
- To obtain best results is better to use the appliance on dry hair, as
it is much easier to control the hair and the results.
- Comb hair well before cutting. Make sure that there are no tangles
or knots.
- Hold the appliance in calm and relaxed manner in order to ensure
maximum control of the cut and uniform result. Proceed to use
short cuts gradually going around the head.
- Leave the hair a little longer than desired length as it can always
be altered later.
- While working adapt the comb/comb guide to the desired result.
To Next Page
Loading...
Need help?
General
