Taurus ICONIC DIGITAL ADVANCE - Changing the Filters

IMPORTANT: Filters washable with water, but
they must be left to dry for at least 24 hours in the
sun before using them again.
CLEANING THE ROTARY BRUSH (C1/C2):
- TO REMOVE THE BRUSH:
- TURN THE ROTATING BUTTON ON THE
SIDE OF THE FITTING TO THE LEFT IN
ORDER TO RELEASE THE BRUSH (FIG.7)
- TAKE OUT THE ROLLER AND CLEAN WITH
THE CLEANING TOOL (P) INCLUDED IN THE
PRODUCT.
- TO REASSEMBLE, FOLLOW THE ABOVE
INSTRUCTIONS BUT IN REVERSE.
SUPPLIES:
- Supplies can be acquired from distributors
and authorised establishments (such as lters,
etc...) for your appliance model.
- Always use original supplies, designed speci-
cally for your appliance model.
- These supplies are available in specialist
shops.
HOW TO REMOVE THE BATTERIES FROM
THE INTERIOR OF THE DEVICE:
- CAUTION: It is important that the batteries are
fully discharged prior to its withdrawal from the
apparatus.
- CAUTION: the appliance must be disconnec-
ted from the supply mains when removing the
batteries.
TO REMOVE THE BATTERIES, ONCE THE
LIFE OF THE APPLIANCE, PROCEED AS
FOLLOWS:
- Safely remove the battery from its housing by
pressing the two side buttons on the battery
(D), located at the rear of the vacuum cleaner.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Remove the battery from the appliance if you
are not intending to use the appliance during
an extended period.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle. (Fig.4)
- Close the lid of the dust box.
CHANGING THE FILTERS:
- Dust tank lter, it is advisable to be changed
at least once a year or every 50 hours of the
appliance’s use.
- Air outlet HEPA lter (high efciency air lter
that efciently retains spores, ash, sawdust,
pollen…), it is advisable to change it a least
once a year or after every 50 hours of use.
TO REMOVE THE FILTERS:
- Remove the lter from the tank, turning the
bottom part of the tank (O) to the left and remo-
ve the cyclone from inside the tank by pulling it
out. You can see that the lter is located inside
the cyclone. (Fig.5)
- Remove the outlet EPA lter, open the cover by
pressing the button to remove the outlet lter
cover (M) (Fig.6).
- To assemble the lter, proceed in reverse order
as explained in the previous section.