Taurus Ideal Lithium Cross ID All-Over - MAINTENANCE AND COMPONENT HANDLING; Filter and Cyclone Removal;Reassembly; Brush Removal and Cleaning; SUPPLIES

TO REMOVE THE FILTERS:
- Uncouple the appliance’s dust box by pressing
the dust box release button (T) and turning
the box in the direction shown by the arrows.
(Fig. 7).
- Remove the cyclone from its housing. (Fig. 8).
- To remove the HEPA lter, turn it slightly to the
right to free it from the cyclone. (Fig. 9)
- Remove the HEPA lter protector
- To reassemble the lter, proceed with the
above instructions, in reverse order.
- Be sure to put the protector back on the HEPA
lter
TO REMOVE THE BRUSH:
- Move the button at the bottom of the brush
base outward to release the brush. (Fig. 10).
- Remove the brush and clean.
- To reassemble, follow the above instructions
but in reverse.
SUPPLIES
- Supplies can be acquired from distributors and
authorized establishments (such as lters, etc.)
for your appliance model.
- Always use original supplies, designed speci-
cally for your appliance model.
HOW TO REMOVE THE BATTERIES FROM
THE INTERIOR OF THE DEVICE:
- Caution: It is important that the batteries are
fully discharged prior to its withdrawal from the
apparatus.
- Caution: the appliance must be disconnected
from the mains when removing the batteries.
TO REMOVE THE BATTERIES, ONCE THE
LIFE OF THE APPLIANCE, PROCEED AS
FOLLOWS:
- Pull the battery upward to remove it from its
housing. (Fig. 11).