Taurus TASTY MULTIPOT - Product Description; Lid Components; Motor Body Components; Included Accessories

English
ELECTRIC PRESSURE COOKER
TASTY MULTIPOT
DESCRIPTION
LID
A Lid handle
B Lid
C Steam release valve
D Lock indicator
E Lid sealing collar
F Inner cover
G Cover sealing gasket
H Floating valve
I Cover insert
MOTOR BODY
J Cool touch handles
K Condensation collector slot
E Lid close area
M Removable pot
N Static inner pot
O Heating plate
P Temperature sensor
Q Control panel
R Extractable power cable
ACCESSORIES
S Measuring jug
T Spoon
U Condensation collector
V Steaming basket
CONTROL PANEL (Q)
Poultry – Aves (chicken, turkey…)
Steam – Cocción al vapor
Bean/Chilli – Legumbres/Chili
Soup/Broth – Sopas/Caldos
Slow Cook – Cocción lenta
Sauté – Sofritos
Reheat – Recalentar
Yoghurt – Yogur
Keep warm – mantener caliente
Sterilis – Esterilizar
Rice – Arroz
Multigrain – Cereales
Porridge – Papillas
Meat/Stew – Carne/Estofados
Sous vide – Cocción a baja temperatura
Dessert – Postres
Display
DIY – Función manual
Delay/Start – Retrasar tiempo
Start/Cancel – Comenzar/Cancelar
USE AND CARE:
- Fully unroll the appliance’s power cable before
each use.
- Do not use the appliance if its accessories are
not properly tted.
- Do not use the appliance when empty.
- Do not use the appliance if the ON/OFF switch
does not work.
- Do not move the appliance while in use.
- Use the appliance handle/s to lift or move it.
- Do not tip the appliance over while it is in use
or connected to the mains.
- To keep the non-stick coating in good
condition, do not use metal or pointed utensils
on it.
- Do not exceed the appliance’s work capacity.
- Disconnect the appliance from the mains when
not in use and before undertaking any cleaning
task.
- Store this appliance out of reach of children
and/or those with reduced physical, sensorial
or mental abilities or who are unfamiliar with
its use
- Do not put the appliance away if it is still hot.
INSTRUCTIONS
BEFORE USE:
- Make sure that all the product’s packaging
material has been removed.
- Before using the product for the rst time, clean
the parts that will come into contact with food in
the manner described in the cleaning section.
- Prepare the appliance according to the function
you wish to use.
- Fitting the condensation collector:
- Fit the condensation collector into the
corresponding slot. (Fig. 1)
- Fitting and removing the cover and the sealing
gasket:
- Make sure that the cover and the sealing
gasket are positioned correctly on the inside of
the lid
- To remove, pull metal part up to separate the
bottom from the lid. (Fig. 2)
- To ret it, place the bottom cover on the lid’s
central insert and press down until it clicks into
place. (Fig. 2)