Taurus TBG-150 - Page 5

After Sales Support TEL: 07 3188 2025 WEB: h e l p d e s k @d u o n s .c o m .a u
5Bench Grinder
After Sales Support TEL: 07 3188 2025 WEB: h e l p d e s k @d u o n s .c o m .a u
- Never yank the cord to disconnect it from the socket. Keep the cord away from heat, oil
and sharp edges.
12 - Secure work
- Where possible use clamps or a vice to hold the work. It is safer than using your hand.
13 - Do not overreach
- Keep proper footing and balance at all times.
14 - Maintain tools with care
- Keep cutting tools sharp and clean for better and safer performance.
- Follow instruction for lubricating and changing accessories.
- Inspect tool cords periodically and if damaged have them repaired by an authorized
service facility.
- Inspect extension cords periodically and replace if damaged.
- Keep handles dry, clean and free from oil and grease.
15 - Disconnect tools
- When not in use, before servicing and when changing accessories such as blades, bits and
cutters, disconnect tools from the power supply.
16 - Remove adjusting keys and wrenches
- Form the habit of checking to see that keys and adjusting wrenches are removed from the
tool before turning it on.
17 - Avoid unintentional starting
- Ensure switch is in “off” position when plugging in.
18 - Use outdoor extension leads
- When the tool is used outdoors, use only extension cords intended for outdoor use and so
marked.
19 - Stay alert
- Watch what you are doing, use common sense and do not operate the tool when you are
tired.
20 - Check damaged parts
- Before further use of tool, it should be carefully checked to determine that it will operate
properly and perform its intended function.
- Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting and any other conditions that may affect its operation.
- A guard or other part that is damaged should be properly repaired or replaced by an
authorized service centre unless otherwise indicated in this instruction manual.
- Have defective switches replaced by an authorized service centre.
- Do not use the tool if the switch does not turn it on and off.
21 - Warning
- The use of any accessory or attachment other than one recommended in this instruction
BGM6018 Ma 1109-26.indd 5 9/26/11 10:56:03 AM