3.3 - Selecting the clothes load
38
Soak or treat stains before the wash, in order to reduce to need to use the hot
programme.
You save 50% energy by using the 60ºC programme.
- Once the clothes have been sorted, put them into the drum of the machine, separately
according to colour and group, loose piece by piece, as per the following proportions:
Beffore putting the clothes into the machine, you should:
- Separate the clothes into three lots (cotton, synthetics and wool).
- Within each group, separate the coloureds from the whites.
Cotton maximum 5,5 kg.
Synthetics maximum 2,75 kg.
Wool maximum 1 kg.
3.4 - Selecting the right program
Once the clothes have been sorted into fabric types and colours, you need to select the right
program and temperature. SEE PROGRAM TABLE (Section 8).
3.6 - How to get the best performance
With the machine now loaded, the door closed, the soap drawer compartments filled and
the right program chosen, to start the machine, you just need to PULL OUT THE
PROGRAMMER CONTROL BUTTON (P) OR ON THE PUSH-BUTTON (X).
The machine automatically goes through all the operations included in the wash cycle until
it ends.
The wash is now ready to be hung out dry (or to be ironed in the case of washer - dryers).
3.6-1 - Maximise the load (Section 8)
3.5 - Starting operation
You obtain the most efficient use of energy, water, detergent and time by using the
maximum recommended load.
You save 50% energy by washing one full load instead of two half loads.
3.6-2 - Do you need a pre-wash?
Only for deeply stained laundry !.
You save detergent, water, time and between 5 to 15% of energy through not using the
pre-wash for light and anormally soiled clothes.
3.6-3 - Do you need hot water?
3.6-4 - For washer-dryers: before using the dryer
Select high (> 850 rpm) for the spin before drying, in order to save energy, water and
time during the drying period.
English
To Next Page
Loading...