complete charge of the battery. Never attempt
to over-charge the battery (although it is rec-
ommended that the rst charge of the battery
be of 6 hours in duration).
- Insert the battery into the charger.
- Connect the charger (L) to the jack using the
socket on the appliance. The socket is located
at the lower/back part of the appliance.
- The pilot light will come on to indicate that the
charger is charging the battery.
- At the end of the time period specied above,
remove the battery from the charger.
- When the battery is charged disconnect the
charger from the mains supply.
- NB: Do not use the appliance while it is con-
nected to the charger.
HOW TO CHECK THE BATTERY’S CHARGE
LEVEL:
- Press the ON/OFF button in order to see the
battery indicator lights.
- If no pilot light lights up, this means that the
battery is completely at.
- NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
INSTRUCTIONS FOR USE
BEFORE USE:
- Make sure that product’s packaging has been
removed.
- Before using this product for the rst time, it is
important to make a full charge of batteries.
- Prepare the appliance according to the function
you wish to use:
VACUUMING FUNCTION:
USE:
- Turn the appliance on, by using the on/off
button.
- Select the desired speed.
FITTING AN ACCESSORY TO THE HAND
VACUUM:
- The hand vacuum is designed in such a way
that it allows the following accessories to be
tted: (use the combination that best meets
your requirements). (Fig.1).
- Furniture brush: Equipped with a brush at the
end, which brushes the surface as it is used.–
Crevice nozzle: Specially designed for getting
into cracks and difcult corners.
- Small Turbo brush: Special motorized brush to
remove the hair of pets in upholstery.
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
- Turn the appliance off using the on/off button.
- Clean the appliance.
CLEANING
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with
a few drops of washing-up liquid and then
dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
- Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
- Disconnect the accessories from the vacuum
cleaners air intake. (Fig.2).
- Open the lid of the dust box and empty the
contents into the appropriate waste disposal
receptacle.
- Close the lid of the dust box.
CHANGING THE FILTERS:
- Motor lter, it is advisable to be changed at
least once a year or every 100 hours of the
appliance’s use.
TO REMOVE THE FILTERS:
- Remove the dust tank pulling out without press-
ing any button. (Fig.3)
- Remove the lter from its housing (Fig.4).
- To reassemble the lter, proceed with the
above instructions, in reverse order.
- Engage the dust tank in the vacuum cleaner.
(Fig.5)
CLEANING THE ROTARY BRUSH:(C)
- To remove the brush:
- Turn the rotating button on the bottom of the
To Next Page
Loading...
Need help?
General
Weight and Dimensions
