INTERFACOM, S.A.
I3000100.DOC 6
EXTERNAL LIGHTS CONNECTOR
If the external lights connector is used, each one of the cables must be welded to
the connector in such a position that they have a good contact:
RECOMMENDATIONS FOR THE PROGRAMMING OF A TAXIMETER IN A CAR:
When the installation of the taximeter in the vehicle is completed proceed to
program it using the tariff charger.
Please always connect the charger in the right position, since a wrong position
may block the microchip of the taximeter and the CPU plate.
The programming sequence is as follows:
The programming is started up with the taximeter in the For Hire
position pressing the O pushbutton in the taximeter.
Calculate the constant K by doing a trial run or introducing it directly.
Adjustment of the calendar-clock if necessary.
Tariff recording.
To have more information, see “Operation Manual for the TX30 Tariff Charger”.
To Next Page
Loading...
