EasyManua.ls Logo

Taylor 35 - Maintenance Information

Taylor 35
6 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Maintenance Info
To ensure that you get the maximum enjoyment from this product and a good service life, TAYLOR
recommends that you take a little time to clean the engine and vehicle after use. It is easy to spot a
little problem such as a loose bolt on an engine mount before it becomes a much bigger problem!
It is absolutely essential that only the best quality fully synthetic two-stroke oil is used.
We
recommend Putoline RS959 or Motul 800 oil but there are lots of great products on the market.
This must be mixed at a fuel/oil ratio of 25:1. Only good quality 91+ Octane must be used to prevent the
possibility of detonation or seizure.
Taylor Coil Air Gap Working Range: 0.5-0.9mm
A minimum of a dual stage air filter is very important for protecting your engine, we use the RAM-AIR one.
Proper oiling through the layers of foam is just as if not more important than the filter itself to protect
in dusty conditions. Regular cleaning and re-oiling is required to keep air filtration at its best. The use of an
water resistant Outerwears protective element is recommended for filtering out large debris.
Please ensure that your fuel equipment, and fuel system of the vehicle is kept in a clean condition.
Dirt can play havoc with carburettors leading to much frustration and little fun. Please make sure your
vehicle in-tank fuel filter is in good working order.
A full range of replacement service parts is available to keep your small block powerhouse in top
condition. Just check the spares section with the TAYLOR 35 area of our website.
If you are unsure about carrying out a rebuild, we are more than happy to do it for you for a small charge plus
parts.
Please contact your dealer for advice, or service, if you are in any doubt.