EasyManuals Logo

Taylor 5863 User Manual

Taylor 5863
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Thank you for purchasing a Taylor® Timer. Your Taylor®
timer is an example of superior design and craftsmanship.
Please read this instruction manual carefully before use.
Keep these instructions handy for future reference.
Splash ‘n’ Drop Timer
Instruction Manual
5863
Battery Information
1. This timer operates on 2 AAA batteries (included. Remove
any plastic wrap from the batteries before proceeding.)
Some models have a static cling label on the lens to
prevent scratching. Please remove before use.
2. Open the battery compartment cover on the back of
the timer.
3. Insert the 2 AAA batteries with the correct polarity
orientation. (Please note: Do not mix old and new
batteries. Do not mix alkaline standard (carbon-zinc)
or rechargeable (nickel-cadmium) batteries. Do not
dispose of this product or batteries in re, as batteries
inside this product may explode or leak.)
4. Replace the battery compartment cover.
5. Replace both batteries if “Lo” appears on the screen or
if readings grow dim or irregular.
Clock Setting
1. Press and hold “VOL (TIMER/CLOCK) for 3 seconds until
the ”CLOCK” icon and digits appear.
2. Press “HR” to set the hours. Press “MIN” to set the
minutes. Press “SEC” to set the seconds. Press and hold
the buttons to advance the digits quickly.
3. Press and hold “VOL (TIMER/CLOCK) for 3 seconds to
return to TIMER mode if desired.
Timer setting
1. Press and hold “VOL (TIMER/CLOCK) for 3 seconds until
the “TIMER” icon and digits appear.
2. Press “HR” to set the hour. Press “MIN” to set the
minutes. Press “SEC” to set the seconds. Press and hold
the buttons to advance the digits quickly.
3. Press “START/STOP” to start the timer.
4. To pause the timer, press “START/STOP”. Press to start
timing again. To reset timer to zero, rst pause the timer,
then press “HR” and “MIN” at the same time.
5. When the timer reaches zero, the alarm sounds and the
timer begins to count up. Press “START/STOP” to stop the
alarm. Press “START/STOP” again to recall the last set
time. Press “HR” and “MIN” at the same time when the
timer is paused to reset to zero.
6. Press and hold “VOL (TIMER/CLOCK) for 3 seconds to
return to CLOCK mode if desired.
7. The timer will time up to 24 hours, 59 minutes and 59
seconds.
Leading the Way in Accuracy®

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor 5863 and is the answer not in the manual?

Taylor 5863 Specifications

Operating Environment IconOperating Environment
heat resistance167°F
water resistanceIP65 rated
impact resistance4 foot drop
Power IconPower
battery type2 AAA
battery includedYes
Timekeeping and Alarms IconTimekeeping and Alarms
maximum timekeeping24 hours, 59 minutes, 59 seconds
alarm volume settings4 settings
clock function12 hour

Related product manuals