14
Models RD30/RC25Operating Procedures
Step 13
Align the draw spout assembly with the door. Place the
draw spout mounting plate over the draw spout
assembly and align the holes.
Figure 15
Step 14
Using the thumb screws, fasten the draw spout
assembly and draw spout mounting plate to the door .
Figure 16
Step 15
Place the large o- ring into the groove on the back side
of the door and lubricate the o- ring. Install the door
bearing onto the hub on the back side of the door with
the flanged end of the bearing facing the door .
Figure 17
Note: Do not lubricate the door bearing.
Step 16
Position the door on the freezer studs at the front of the
freezing cylinder . Press the door firmly into place.
Note: The torque rotor will protrude through the hole
in the center of the door.
Figure 18
Step 17
Install the handscrews on the studs. Tighten the
screws equally, using a criss- cross pattern. Do not
over- tighten the handscrews.
Figure 19
To Next Page
Loading...