EasyManuals Logo

Taylor SampleSizer Manual

Taylor SampleSizer
2 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background image
Timesaving Testing Tools from Taylor
SampleSizer 10/25 mL (#6190) AND
SampleSizer 44 mL (#6191)
Many Taylor drop tests are done with a 25 mL or 10 mL
water sample in either the #9198 sample tube or a 2000
Series
comparator block. A 44 mL sample is used for the
pH color comparison test in the 2000 Series block. Using
these new tools, you won’t need to ick off the excess water
to get the meniscus to rest precisely on the ll line. Simply
lower the appropriate SampleSizer
®
into the test vial lled
with the water to be tested. It will displace exactly the right
amount to leave the correct volume to perform the test! The
SampleSizer is removed once the extra water is splashed out.
Clean and dry it before storing or using it for another test.
These tools are made from machined aluminum anodized
for longer life.
SpeedStir (#9265)
The SpeedStir
®
makes quick work of drop tests performed
in Taylors #9198 sample tube. (Note: Any 10 or 25 mL
test performed in a 2000 Series comparator block also can
be done in the #9198 sample tube.) This palmsize, portable
magnetic stirrer will thoroughly incorporate each addition
of reagent in a fraction of a second. No more manual swirling!
Place the water sample on the mixing platform then gently
drop in the Teon
®
-coated stir bar. Use the pad to turn
the unit on in well-lit conditions. Use the pad to start the
stirrer when ambient light is poor
six LEDs below the
mixing platform will light up to make color changes in the
test sample easy to see. Press the same pad to stop the
stirring action, or the unit will turn itself off after ve minutes.
The SpeedStir runs on four AA alkaline batteries at 600 rpm.
Made of high-impact polystyrene, it is water-resistant (you
can spill water on it, but you should not submerge it).
SampleSizer #6190
1” w x 4
3
/4” h
Available singly or
in a multipack of 12
SpeedStir
4
5
/8” l x 1
3
/4” w x 1
5
/8” h
(Shown with #9198 sample tube
supplied in #9265 Start-up Pack)
SampleSizer #6191
7
/16” w x 4
3
/4” h
Available singly or
in a multipack of 12

Other manuals for Taylor SampleSizer

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Taylor SampleSizer and is the answer not in the manual?

Taylor SampleSizer Specifications

General IconGeneral
BrandTaylor
ModelSampleSizer
CategoryTest Equipment
LanguageEnglish