Taylor SampleSizer Manual

DATA SUMMARY
SampleSizer 10/25 mL SampleSizer 44 mL SpeedStir
Taylor part number #6190 (single)
#6190-12 (12-pack)
#6191 (single)
#6191-12 (12-pack)
#9265
use with #9198 sample tube or new
models of 2000 Series
comparator blocks with
flanges (#9056, #9057,
#9058)
new models of 2000 Series
comparator blocks with
flanges (#9056, #9057,
#9058) and labs K-0200
and K-0206
#9198 sample tube
Taylor replacement part
numbers
NA NA magnetic stirrer (only) #6100
1" magnetic stir bar #6101
sample tube #9198
4 AA alkaline batteries #6105
dimensions 1" dia. x 4 3/4" h 7/16" dia. x 4 3/4" h 4 5/8" l x 1 3/4" w x 1 5/8" h
weight 4.1 oz. 0.9 oz. 7.5 oz. (with batteries)
material anodized machined
aluminum
anodized machined
aluminum
high-impact polystyrene
power NA NA 4 AA alkaline batteries
(approx. 300 tests with light on;
400 tests with light off)
operating temperature range NA NA
36°–120°F; 2°–49°C
revolutions per minute NA NA 600 after 2 seconds
illumination NA NA 6 LEDs
seal submersible
(wipe dry after use)
submersible
(wipe dry after use)
water-resistant: do not
submerge (wipe dry after use)
instructions for use on product packaging on product packaging on product packaging
1. Rinse and fill #9198 sample tube with water
to be tested in excess of desired volume.
4. …all excess water will be displaced.
2. Orient SampleSizer for desired test volume:
an arrow indicates the skinny end goes first
for a 25 mL sample.
5. Tool should touch bottom.
3. Slowly lower the tool into the sample…
6. Carefully remove SampleSizer to avoid
dragging out remaining water. Voilà!
overflow
SampleSizer Demo Using #6190
rev. 111312-ps

Taylor SampleSizer Specifications

General

Brand	Taylor
Model	SampleSizer
Category	Test Equipment
Language	English