EasyManua.ls Logo

TBH BF100R CAB AF5 - User Manual

TBH BF100R CAB AF5
106 pages
Go to English
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
TRIPLE PROTECTION
FOR PEOPLE, ENVIRONMENT AND MACHINES
Original Betriebs – und Wartungsanleitung
AF5 AF5 mit Vorfiltermodul
Rev. 1.4 12.08.19
BF100R CAB AF5

Table of Contents

Questions and Answers

  • J
    Johnny WatkinsAug 16, 2025
    What to do if my TBH Water Filtration System doesn't start and the run/standby button is blinking?
    • D
      Darlene PetersonAug 16, 2025
      If the TBH Water Filtration System doesn't start and the run/standby button is blinking, it could be in standby mode. Try pushing the run/standby button. Another possibility is incorrect wiring of the interface. Check the interface: Pin 7 should be +, and Pin 8 should be -. If there's a jumper between pins 9 and 10, use the remote control to switch the system into run mode, as the remote control is dominant in this case.
  • A
    aaroncoleAug 19, 2025
    What to do if the temperature error indicator lights up on my TBH Water Filtration System?
    • F
      frank00Aug 19, 2025
      If your TBH Water Filtration System displays a temperature error, shut it down and allow it to cool. Then, inspect the ambient temperature and the extraction hose for any blockages or issues with its length or profile. After addressing these potential causes, restart the system. If the error persists, it indicates a more complex issue.
  • T
    Tiffany GravesAug 22, 2025
    How to troubleshoot a TBH Water Filtration System that doesn't start and has no display?
    • L
      Logan WallerAug 22, 2025
      If your TBH Water Filtration System is not starting and there is no display on the front panel, there could be several reasons: * The power cable might not be connected, so ensure it is properly connected. * The fuse might be defective or not installed, so check the fuses and replace them if needed. * The electric socket might not be providing any voltage, so check the circuit breakers. * The power switch might be off, so turn it on. * The mains supply voltage might be incorrect, so verify the supply voltage. * If it's a three-phase network, it might be without a neutral conductor, so check the connection to the mains power supply.
  • K
    kfloresAug 25, 2025
    Why is the yellow warning lamp blinking on my TBH Water Filtration System and the filter saturation indicator is showing green and yellow?
    • X
      xrobinsonAug 26, 2025
      If your TBH Water Filtration System is running but the yellow warning lamp is blinking and the filter saturation indicator is lit with green and yellow lights, it means the filter is partially saturated. Green indicates the filter saturation is okay, yellow means you should order replacement filters, and red would mean the filter is fully saturated and needs immediate replacement.
  • M
    Margaret VegaAug 28, 2025
    What to do if my TBH Water Filtration System has low extraction performance?
    • V
      Vanessa WatkinsAug 28, 2025
      If your TBH Water Filtration System has no or low extraction performance, but the filter saturation indicator isn't suggesting a filter replacement, check the intake piping for clogs, defects, kinks, or disconnections and clean or replace the intake piping. Also, verify that the extraction performance is set correctly and increase it using the speed controller on the front or the remote control.
  • I
    isimmonsAug 31, 2025
    What does it mean when the filter-saturation indicator lights up (green+yellow+red) on my TBH Water Filtration System?
    • F
      fmarshAug 31, 2025
      If the filter-saturation indicator on your TBH Water Filtration System is lit with green, yellow, and red lights, it means the filter is fully saturated. You need to determine which filter needs replacement based on the filter status indicator, depending on the type of system, and order a replacement filter.
  • C
    Carol VegaSep 3, 2025
    Why is my TBH Water Filtration System operating roughly or vibrating strongly?
    • C
      Casey RobinsonSep 3, 2025
      If your TBH Water Filtration System is operating roughly or vibrating strongly, it could be due to a defective motor bearing. Consider replacing the motor. Alternatively, there might be impurities on the motor fan wheel; in this case, remove any impurities from the motor fan wheel and check the filter for leakiness.
  • L
    Lisa WilliamsSep 6, 2025
    Why can't I adjust the rotational speed on my TBH Water Filtration System?
    • C
      Clinton WrightSep 6, 2025
      If the rotational speed of your TBH Water Filtration System cannot be adjusted at the system, it is because external speed control is dominant and has priority over manual adjustment of the rotational speed.
  • B
    Brent CaldwellSep 9, 2025
    What does it mean if my TBH Water Filtration System doesn't start and the turbine error indicator lights up?
    • T
      Tina BuckSep 9, 2025
      If your TBH Water Filtration System is not starting, and you hear an acoustic warning signal with the turbine error indicator lit, it indicates a turbine malfunction or failure. Turn off the system.
  • K
    katherine63Sep 12, 2025
    Why can't I adjust the rotational speed of my TBH Water Filtration System via the interface?
    • T
      Troy Perry Jr.Sep 12, 2025
      If the rotational speed of your TBH Water Filtration System cannot be adjusted via the interface, it is because external speed control is dominant and has priority over manual adjustment of the rotational speed.

TBH BF100R CAB AF5 Specifications

General IconGeneral
BrandTBH
ModelBF100R CAB AF5
CategoryWater Filtration Systems
LanguageEnglish