Why is my TBI PRO Engineering Lawn and Garden Equipment light on, but no longer attracts insects?
If the TBI PRO Engineering Lawn and Garden Equipment light is on but no longer attracts insects, it could be due to two reasons. First, the blacklight's power may have diminished with age, requiring a bulb replacement. Second, the attractant bait might no longer be effective, so you should replace the attractant cartridge.
What to do if there is sparking between grid rods in TBI PRO Engineering ELECTRONIC ZapLikePRO 360?
If you observe intermittent or continuous sparking between the grid rods of your TBI PRO Engineering Lawn and Garden Equipment, there are a couple of potential causes. One possibility is that the gap between the grid rods is too small; in this case, unplug the unit and carefully bend the grids back into proper alignment. Alternatively, the grid may be clogged with foreign material. If this is the case, clean the grid using an air blower.
Why is the light on but there is no high voltage on the grid in TBI PRO Engineering Lawn and Garden Equipment?
If the light is on, but there is no high voltage on the grid of your TBI PRO Engineering Lawn and Garden Equipment, it could be due to shorted grids. Examine the grid and clean it using an air blower. Alternatively, the transformer may be defective, requiring replacement by the manufacturer.
How to fix the light if it is off and there is no high voltage on the grid in TBI PRO Engineering Lawn and Garden Equipment?
If the light is off and there is no high voltage on the grid for your TBI PRO Engineering Lawn and Garden Equipment, it could be due to several reasons. First, check the fuse or circuit breaker and the extension cord to ensure there is electricity. Second, make sure the lamp is installed correctly, checking all sockets for proper fit and alignment. Third, the starter may be faulty, requiring replacement by the manufacturer. Finally, the bulb may be burnt out, requiring replacement.
Essential safety warnings and precautions to follow when operating the device.
Instructions for optimal placement and use in both indoor and outdoor environments.
Guide to replacing the attractant, including handling and safety instructions.
Steps for replacing the UV bulb and advice on its efficiency and replacement frequency.
Details on input voltage, light source, and high voltage grid specifications.
Solutions for typical problems encountered with the device's operation and performance.
Ways to contact customer support for assistance, including email, chat, and phone.
General| Brand | TBI PRO Engineering |
|---|---|
| Model | ELECTRONIC ZapLikePRO 360 |
| Category | Lawn and Garden Equipment |
| Language | English |
To Next Page