RaLights By TBI Pro
17
STEP 1
Hold the light in position and ensure
the light is level.
Mark the hole positions and again
check to ensure the light is level.
STEP 2
Predrill the marked location of the
holes.
Prior to drilling, ensure the area
where the light is being attached is
free from wires, plumbing or other
obstructions.
STEP 3
Using a long Head screwdriver, secure
the light in place with the provided
screws.
STEP 4
Adjust the light and the solar panel to
maximize light exposure to the panel
and angle of the light to the desired
area.
To Next Page
Loading...