Need help?Do you have a question about the TC Electronic G-MAJOR 2 and is the answer not in the manual?
General| Type | Multi-Effects Processor |
|---|---|
| Form Factor | Rackmount |
| Rack Spaces | 1U |
| Sampling Rate | 44.1 kHz |
| A/D Conversion | 24-bit |
| D/A Conversion | 24-bit |
| Display | LCD |
| Input | 2 x 1/4" TRS |
| Output | 2 x 1/4" TRS |
| Effects Types | Delay, Pitch |
| Presets | 100 |
| MIDI | In/Out |
| Power Supply | 9V DC |
| Dimensions | 19" x 1.75" |
Details physical controls like knobs, buttons, and wheels on the front panel.
Explains LEDs, meters, and status lights indicating device state and signal levels.
Describes the screen elements, including preset numbers and routing information.
Covers keys for activating/deactivating and editing effect blocks.
Details keys for global settings, MIDI, bypass, and menu navigation.
Explains the wheel and keys used for adjusting parameters and recalling presets.
Describes connecting the unit in a serial configuration with a preamp and power amp.
Explains serial connection to a preamp and one or two combo amplifiers.
Details a parallel connection scheme using a line mixer.
Illustrates integrating the unit with external pedals and a MIDI controller.
Instructions for naming or renaming presets when saving them.
Details the process for backing up user presets to external MIDI devices.
Overview of how to navigate and adjust parameters within the Global Menu.
Explains the Kill Dry setting for parallel setups, which removes the direct signal.
Guides on selecting pedal types and calibrating expression pedals.
Covers MOD Master behavior and setting the tuner's reference frequency.
Details tuner accuracy modes, range selection, tempo synchronization, and effect muting.
Configures input sensitivity and output level ranges for optimal signal matching.
Covers MIDI channel, program change, bulk dump, and clock synchronization settings.
Explains how to map MIDI program changes and reset the MIDI map.
Configures the four modifier channels for external control.
Covers bypass, tuner mute, and relay switching for system management.
Adjusts global and preset output levels, including boost functions.
Remotely toggles individual effect blocks like Compressor, Delay, etc.
Allows remote activation or deactivation of the Equalizer.
Configures external control sources like Learn, Pedal, or CC messages.
Details the two steps required for assigning external controllers to parameters.
Explains how to set MinOut, MidOut, and MaxOut for modifier response curves.
Provides a step-by-step example of assigning an expression pedal for Whammy effect control.
Lists parameters that can be assigned to modifiers, varying by effect block.
Details accessing the menu and setting individual preset output levels.
Explains global settings for input and output levels, useful for volume swells.
Describes the Kill Dry setting for parallel loops to remove the direct signal.
To Next Page