To Next Page

To Previous Page

14 TC2290 User Manual

4.3 Insert vs Aux Eect

The TC2290 can be inserted directly into an eect slot on a single channel, as described above, which passes the entire signal through the eect. In this case, note that

the direct input signal becomes mono before it is panned, either statically or modulated. This occurs when the PAN/DYN section DIRECT button is engaged.

However, the TC2290 can also be added to an auxiliary bus, and one or more channels can send a portion of their signal to this bus to be processed by the eect.

The output of the eect is then mixed back in with the rest of the tracks. This diers from an insert eect in that the TC2290 isn't aecting the track's entire signal,

so the direct signal cannot be modulated using the MOD buttons in the PAN/DYN section. In this setup, the Mix parameter should always be set to 100%.

4.4 Mono/Stereo Operation

The TC2290 can be used both as a mono instance on mono tracks and a stereo instance on stereo tracks. Depending on the specic DAW, a mono in/stereo out may also

be available.

In the case of a mono out instance, the output signal is made by outputting the left plug-in channel only. In this case, panning should not be used.

4.5 Travel Period and Module Connection (when you have purchased the DT version):

You can try out the plug-in before purchasing or receiving your purchased Desktop Controller by requesting a Free iLok Trial License, which will enable full

functionality for 14 days.

When you receive and connect your purchased Desktop Controller you will no longer need an iLok License to have full functionality in the plug-in or via the

Desktop Controller.

60-day Travel Period

If the Desktop Controller is disconnected, full plug-in functionality will be available for 60 days, after which the plug-in requests re-connection to the hardware unit.

Once the hardware unit is re-connected, all controls become available.

Download and install the

plug-in and connect

the module

Disconnect Module 60 days... Reconnect Module

Full Fuctionality

Processing, controls

available for 60 days

countdown

Processing Only Full Fuctionality Restored

60 day count downLink to product page

with store nder