Tchibo Cafissimo pure+ - Removing protective films and packaging materials; Unpacking and Preparation; Initial operation - prior to first use; Machine Setup and Water Tank Filling

26
Removing protective films and packaging materials
1. Take the machine out of the packaging.
2. Pull all protective films off the machine and remove all packaging
materials and adhesive transport protection tape.
3. Remove the transport protec-
tion under the water tank.
The packaging materials protect the machine during transport.
Keep the packaging in case you need to transport or return the
machine.
Initial operation - prior to first use
1. Set up the machine ...
... at least 15 cm away from walls.
... on a level worktop or surface that
is not sensitive to moisture.
... near a wall socket. The length of the
connection cable is approx. 80 cm.
... at a distance of at least 1 m away from hot, flammable surfaces
(hobs, ovens, radiators, etc.).
2. Make sure that the used
capsule container is correctly
inserted into the front drawer.
The front drawer needs to be
pushed in all the way and the
drip tray inserted correctly.
3. Pull the water tank straight
up and out of the machine.
4. Clean the water tank as
described in the chapter
“Cleaning”.
5. Fill the water tank with fresh,
cold tap water or drinking
water up to the MAX mark.
6. Reinsert the water tank into
the machine . Press it down as
far as it will go.
15 cm
15 cm
15 cm
15 cm
en
113420 en Cafissimo Pure+ v6.indd 26113420 en Cafissimo Pure+ v6.indd 26 06.01.23 15:1806.01.23 15:18