24
Removing protective films and packaging materials
1. Take the machine out of the packaging.
2. Pull all protective films off the machine and remove all packaging materials.
The packaging material protects the machine during transport.
Keep the packaging in case you ever need to transport or return the machine.
Initial operation – prior to first use
Do not insert any capsules into the machine during initial operation.
1. Place the cup tray onto the residual
water tray cover in the direction
shown.
2. Push the residual water tray into
the machine as far as it will go.
The residual water tray is held
in place by magnets.
3.
Pull the water tank
straight up and
out of the machine.
4. Clean the water tank as described
in the section “Machine
maintenance”.
5. Then fill the water tank with fresh,
cold tap water or drinking water
up to the handle.
6. Reinsert the water tank into the
machine from above.
Latches
The two hook-like latches on the water
tank must catch on the back of the
casing and click into place. The water
tank might otherwise be incorrectly
inserted or inserted at an angle.
7. Press the water tank all the way
down until the top is flush with the
casing.
8. The lever must be in the down
position. Fold it down if necessary.
9. Plug the mains plug into an easily
accessible wall socket.
10. Place an empty cup underneath
the beverage spout.
To Next Page
Loading...
