EasyManuals Logo

TCL 65P615 User Manual

TCL 65P615
20 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
9
Connections and Setup
Switching On
Follow the instructions on this page on how to switch on your TV set and
the remote control before going on to following pages describing how to
use the channel set-up procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
-Onlyusethebatterytypesspecied.
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
-Donotexposebatteriestoexcessiveheatsuchassunshine,reor
thelike,throwtheminare,rechargethemortrytoopenthem,as
this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using it
for a long period of time.
- Attention should be drawn to the environmental aspects of battery
disposal.
2. Connect the power cable FIRST to the television, THEN to a mains
socket. (
Note:
if the power cable is connected to the television, please
only connect the power cable to the mains socket.
)
Your TV set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cable, do
not, under any circumstances, connect it to a mains socket, as there is
a risk of electric shock.
Note:
the gures are for representation only, the location of power
socket of the television might differ depend on the model.
3. Connect an outside aerial to the ANTENNA IN socket at the back of
the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
connectinganexternalaerialorotherequipmenttted.
Note:
if you want to receive the signal from your cable or cable box,
please connect a coaxial cable to the ANTENNA IN socket at the back
of the TV set.
4. When powered on, the TV will be turned on directly or be in standby
mode.
If the power indicator lights up, the TV set is in standby mode. Press
the button on the remote control or on the TV set to turn on the TV.
Switching Off
To put the TV set into standby mode, press the button on the
remote control. The TV set remains powered up, but with low energy
consumption.
To switch off the TV set, unplug the mains socket from the mains
outlet.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TCL 65P615 and is the answer not in the manual?

TCL 65P615 Specifications

General IconGeneral
Screen shapeFlat
Response time10 ms
Display diagonal65 \
Display brightness320 cd/m²
Display technologyLCD
Native aspect ratio-
Native refresh rate60 Hz
Peak luminance ratio65 %
LED backlighting typeDirect-LED
Viewable size diagonal1640 mm
Display diagonal (metric)165.1 cm
Motion interpolation technologyPPI (Picture Performance Index) 1500
Dynamic contrast ratio marketing nameMega Contrast
Product colorBlack
Mercury content0 mg
Ambient lightingYes
Heavy metals freeHg (mercury)
Panel mounting interface300 x 200 mm
Video appsAmazon Prime Video, Netflix, YouTube
Smart modesGame, Movie, Sports
Lifestyle appsGoogle Apps
Operating system version9.0
Operating system installedAndroid
Hybrid Broadcast Broadband TV (HbbTV) version2
Processor cores4
Audio formats supportedMP3, WMA
Image formats supportedBMP, HEIF, JPG, PNG
Video formats supportedAVI, H.264, H.265, MKV, MP4, MPG, TS, VP9, WEBM, WMV
Picture processing technologyTCL IPQ 2.0 Engine
High Dynamic Range (HDR) technologyHigh Dynamic Range 10 (HDR10), Hybrid Log-Gamma (HLG)
Remote control typeRC802N4
Wi-Fi standards802.11b, 802.11g, Wi-Fi 4 (802.11n)
Bluetooth profilesA2DP, HID
CertificationCE
Audio decodersDolby Digital, Dolby Digital AC4
RMS rated power16 W
Number of OSD languages29
Firmware upgradeable viaNetwork, USB
On Screen Display (OSD) languagesALB, BUL, CRO, CZE, DAN, DEU, DUT, ENG, ESP, EST, FIN, FRE, GRE, HUN, ITA, LAT, LIT, MAC, NOR, POL, POR, RUM, RUS, SER, SLK, SLV, SWE, TUR, UKR
RF connector typeF, IEC
USB 2.0 ports quantity1
Consumer Electronics Control (CEC)T-link
Common interface Plus (CI+) version1.4
Tuner typeAnalog & digital
Analog signal format systemNTSC, PAL, SECAM
Digital signal format systemDVB-C, DVB-S2, DVB-T2
AC input voltage220 - 240 V
AC input frequency50 Hz
Energy efficiency scaleA to G
Power consumption (max)170 W
Power consumption (standby)0.29 W
Power consumption (typical)120 W
Package depth165 mm
Package width1645 mm
Package height1000 mm
Package weight25800 g
Weight and Dimensions IconWeight and Dimensions
Depth (with stand)355 mm
Height (with stand)892 mm
Weight (with stand)18600 g
Depth (without stand)85 mm
Width (without stand)1450 mm
Height (without stand)843 mm
Weight (without stand)18200 g

Related product manuals