Factory Test & Alignment Specification For MS63F-LA Series (V0.10)
Page 12 of 18
Appendix o “How to upgrade FLASH SW using USB”
There are two methods to upgrade SW using USB,the first one like below˖
¾ In the previous of upgrade SW using USB,should program mboot bin file”
V8-6328L01-LF1Rxxxbin” by ISP_Tool .
¾ Then switch off TV by removing AC cord.
¾ Copy the SW BIN image “MS6328LA_FULL_UPGRADE.bin” into USB stick (pen drive)
root path
Note:
¾ Plug USB stick to the TV
If there’s already other “
MS6328LA_FULL_UPGRADE.bin” into USB root, it needs
to be deleted or renamed
¾ Press and hold the power key of key board before reconnect AC cord to restart TV for
5-8seconds.
¾ Once USB stick starts blinking, TV is uploading SW BIN image.
¾ When update is successful, TV should restart automatically.
¾ Remember to perform “Factory menu
NVM reset“and then press RCU “OK” key
¾ Switch off TV by removing AC cord
¾ Reconnect AC cord to restart TV and wait few seconds for Eeprom update
The second method ˖
¾ To use this method,there should be SW in mainboard to ensure TV can display normally.
¾ Copy the SW BIN image “
V8-6328L01-LF1RXXX.bin” into USB stick (pen drive) root
path
¾ Press RCU MENU
Setting
Function
software upgrade
OK
By USB
¾ TV display a warning information ,that means it is upgrading,almost 3minutes later,when
upgrade successful,TV should restart automatically.
Appendix p “How to change ProjectID with RCU”
¾ Process following subsequence IR codes to change projectID: 062598+MENU+xxx
(xxx:ProjectID, ex: 003)
¾ Restart TV
Appendix q “How to upgrade MAC Address
¾ Upgrading MAC address need to use the tool in factory and through serial command, The
specific methods according to the operation of the factory guidance.
Appendix
“Factory Menu Description”
1-Factory hotkey submenu
Item Sub-item Value Note
)DFWRU\
KRWNH\
Off/On
OFF᧶hotkey is invalid
ON ᧶hotkey(Return key) is availability
To Next Page
Loading...
