TCP Direct 8 Series User Manual (English)

To Next Page

INSTRUCTION MANUAL

LED GLASS TUBE T8 LAMP

INSTALLATION INSTRUCTIONS

The basic Type number designation is described as follows:

T8040730E T8040735E T8040741E T8040750E

T8045330E T8045335E T8045341E T8045350E

Installation Instructions

PLUG and PLAY Procedure

1. Turn off the power to the light fixture at the breaker panel

before installation.

2. Open the diffuser from the light fixture.

3. Remove the fluorescent tubes. Please dispose of these

items properly as they contain mercury.

4. Put LED tube into the lighting fixture.

5. Install the LED tubes, close the diffuser.

6. Turn on the power

1.Turn off the power to the light fixture at the breaker panel before installation

2.Open the diffuser from the light fixture.

3. Remove the fluorescent tubes. Please dispose of these items properly as they

contain mercury.

4. Cut the wires shown as the diagram below.

5. Make the new wire connect to branch circuit shown as the diagram below.

6. Replace the cover over the wiring channel.

7. Install the LED tubes, close the diffuser.

8. Turn on the power.

Fig.1 Before the installation

Fig.2 After replacing the LED Tube

Fig.1 Before the installation

Ballast by pass procedure

Installation Instructions

Need help?

Do you have a question about the TCP Direct 8 Series and is the answer not in the manual?

TCP Direct 8 Series Specifications

General

Step-by-step guide for installing LED tubes by plugging them into the fixture.

Step-by-step guide for bypassing the ballast and wiring the LED tubes directly.

Guidance on using only non-shunted lampholders for LED tube installation.

Critical warnings regarding fire, electric shock, and proper installation practices.