To Next PageTo Next Page
Need help?Do you have a question about the TCS WOWSound CV 201 and is the answer not in the manual?
General| Brand | TCS |
|---|---|
| Model | WOWSound CV 201 |
| Category | Media Converter |
| Language | English |
Auditory feedback, main line configuration tool for sound setup.
Adjust sound volumes, map sounds, and select chuff sets.
Setup lighting effects and remap light functions.
Speed matching, prototype calibration, and chuff rate adjustment.
Throttle mode, decoder presets, and factory resets.
Details of CV 201, CV 202, CV 203, and CV 204 for sound features.
List of reset actions corresponding to different values in CV 204.
Steps to determine programming action and enter corresponding CV values.
Procedure for reading CV values using CV 201, 202, 203, and 204.
Constant chuff volume, snifters and automatic sounds can be enabled.
Chuff volume varies with load, similar to prototype operation.
Two-step process to set BEMF Low and High Calibration Points.
Controls chuff volume transition speed based on load changes.
Sets the low BEMF calibration point for prototype chuff volume.
Sets the high BEMF calibration point for prototype chuff volume.
Sets the speed step at which cylinder cocks shut off.
Controls the playback frequency of Random Sound 1.
Controls the playback frequency of Random Sound 2.
Controls the playback frequency of Random Sound 3.
Controls the playback frequency of Random Sound 4.
Sets the time block for Random Sound calculations.
Sets the speed step at which Random Sounds stop playing.
Selects the Whistle Set for Long, Short, and Whistle Quill sounds.
Sets the speed step at which the Proto-Chuff effect starts.
Adjusts the overall volume of the WOWSound decoder.
Sets the Steam Locomotive Chuff Type based on CV 204.
Selects which automatic and random sounds are active.
Sets the speed step at which the Brake Grinding Sound is activated.
Sets which function buttons work in both Light and Sound Modes.
Speeds up or slows down the chuff rate using CV 204.
Controls chuff rate based on individual speed steps.
Selects which Rod Clank sound is played via CV 204.
Sets delay before cylinder cocks sound activates after stopping.
Activates CAM functionality with continuity on Rail A or B.
Enables chuff articulation, directional whistles, and feedback modes.
Controls how fast articulated chuffs go into and out of sync.
Sets how long the locomotive must be idle before sound shuts off.
Sets the lowest possible volume for the Chuff sound.
Controls which Bell sound is active.
Selects the Whistle Quill variety (Short, Medium, Long, Random).
Controls which Cylinder Cocks sound is active via CV 204.
Controls which Idling Sound is active via CV 204.
Controls how accelerating/decelerating affects chuff volume.
Subtracts value from forward chuff volume to balance stiffness.
Subtracts value from reverse chuff volume to balance stiffness.
Adjusts rod clank volume based on BEMF levels.
Controls how decelerating affects rod clank volume.
Sets the speed range for Rod Clank playback.
Selects between traditional and prototype throttle operation modes.
Controls the acceleration rate in switching mode.
Controls the deceleration rate in switching mode.
Controls the acceleration rate in mainline mode.
Controls the deceleration rate in mainline mode.
Sets the volume for a particular Sound Type.
Re-maps any sound to any button or random sound output.
Sets the volume of each sound independently.
Allows factory resets and loading of saved user presets.
Describes the brake application and squeal sounds on button press.
Explains CAM wire connection and activation via User Options.
