Need help?Do you have a question about the TdA electronics HN1000TX and is the answer not in the manual?
General| Brand | TdA electronics |
|---|---|
| Model | HN1000TX |
| Category | Washer |
| Language | English |
Check if the plug is properly inserted and the door is closed.
Verify the tap is open and the hose is correctly connected and not kinked.
Ensure the drain hose is positioned at least 80cm but not more than 32 inches above the floor.
Check the drain hose is not blocked or positioned too high.
Verify that the detergent used is suitable for washing machines and not hand wash.
Ensure the machine is level and properly positioned to prevent damage or instability.
Connect the plug to an efficient earth connection, ensuring voltage and frequency match.
Connect the water inlet hose to a cold water tap with a 3/4" thread and a filter.
Connect the drain hose to a drain pipe or sink, ensuring it's not kinked and at the correct height.
Connect the water inlet hose to the cold water tap, ensuring correct thread and connections.
Select the most suitable program for the laundry type and fiber to ensure perfect washing.
For synthetics/wool, the cycle stops before spinning to prevent creasing. Complete with spin or drain.
Load the machine correctly according to fiber type to achieve excellent washing results.
Separate laundry by fiber and dirt level, load evenly, and pull the handle to open the door.
To Next Page