Accessories
User’s Guide
Remote Control
2 x AAA Battery
Wall Mounting Information
Stand and wall-mounted (optional)
Your LCD TV is able to accommodate wall mounting with the use of a wall mount bracket (not supplied with LCD TV, please
contact your local hardware store) and the mounting hole screw size (M4X10) on the back of the unit.
We recommend removing the TV stand prior to mounting the TV on the wall. Please refer to the figures and procedure below.
How to remove/re-install the stand
How to mount the LCD TV on the wall
1. After detaching the stand, fasten 4 mounting screws (thread size M5X10 - NOT SUPPLIED. Please
2. Fasten wall mounting bracket (NOT SUPPLIED with LCD TV, please contact your local hardware store)
with screws on the wall.
contact your local hardware store) into the 4 screw holes on the rear cover, see the figure below.
3. Carefully check for the strength of the connection before releasing the LCD TV.
NOTE : For more detailed instructions please refer to your “after market” wall mounting instruction book.
Thread hole size – M4 x 10 depth (TV mounting screw size) on the TV.
100mm
100mm
100mm
100mm
Contact CardQuick Start Guide
Follow instructions below to remove the base of the TV:
1. Place the unit (face down) on a soft surface.
2. Loosen and remove the 4 screws securing the stand to the TV (per the diagram on right).
3. Gently remove the stand.
4. To reinstall the stand, place the unit (face down) on a soft surface and reverse the above
instructions.
NOTE: Make sure the power is completely disconnected and unplugged before starting.
AC power adaptor
Basic OperationOSD Menu
Multimedia
Operation
Recording
Operation
User Guidance
Information
Maintenance
and Service
6
To Next Page
Loading...
