Teac LX Series - Page 7

Contents
v
Section 1 Preface
Overview 1-2
Features 1-3
About TAFFmat 1-5
Notes on Usage 1-6
Names and Parts 1-8
Front 1-8
Rear 1-10
Recording Times 1-12
Sampling Frequency and Number of Channels 1-13

Section 2 Installation
Connections 2-2
Notes on Connections 2-3
PC System Requirements 2-3
Installing LX-10/20 IEEE 1394 Version 2-4
Installing Interface Card 2-4
Installing OHCI Driver 2-5
Installing LX Series Device Driver 2-8
Installing LX Navi 2-15
Installing LX-10L/20L LAN Version 2-16
Installing LX Navi 2-16
About IP Address Settings 2-21
Starting Program 2-22
 Starting Navi directly without the LX
Network dialog box displayed 2-21
Inserting and Ejecting Media 2-23
Inserting Media 2-23
Ejecting Media 2-24
About Data on Media 2-24
About Expansion Unit 2-25
About Slot Settings 2-25
About Maximum Sampling Frequency
When Using Expansion Unit 2-25
About Power Supply Connection 2-26
Section 3 Introduction to LX Navi
Outline of Main Window 3-2
Overview of Steps in Recording and Reproduction 3-4
Section 4 Settings
System Settings 4-2
Input Amp Settings 4-5
DC Amp AR-LXDC/DC2 4-5
PA Amp AR-LXPA/PA2 4-6
ST Amp AR-LXST1 4-9
Sensitivity Settings Using TEDS Functions 4-11
Auto Offset 4-13
Calibration By Using Calibrator 4-14
Zero Balance 4-15
Setting Tachometer Pulse Inputs 4-16
Output Amp Settings 4-18
Outline of Trigger Recording 4-19
Repeat Mode 4-19
Interval Mode 4-20
Repeat Mode Settings 4-21
Level Trigger Settings 4-23
Interval Mode Settings 4-24
Saving and Loading Settings 4-25