Need help?Do you have a question about the Teac TD-240A and is the answer not in the manual?
General| Type | Digital Multimeter |
|---|---|
| Continuity Test | Yes |
| Diode Test | Yes |
| Safety Rating | CAT II 600V |
| Display | LCD, 3.5 digits |
| Battery | 9V |
Explains the meaning of WARNING and CAUTION symbols used for safety.
Wiring diagrams for connecting 4-wire and 6-wire strain gauge sensors.
Outlines the step-by-step procedure for setting parameters using the keypad.
Describes calibrating without actual loads using sensor specifications.
Explains calibration using an actual load for higher accuracy.
Details the step-by-step procedure for performing equivalent input calibration.
Explains how to disable the calibration lock feature to allow settings changes.
Outlines the procedure for performing calibration using actual applied loads.
Details the steps to set the zero point of the strain gauge sensor.
Explains how to set the actual load value during calibration.
Describes the function to inhibit changes to setting or calibrated values.
Explains how to select the bridge excitation voltage supplied to the sensor.
Explains how to instantly make the indicated value zero using a key operation.
Guides the user through setting the communication conditions for the RS-232C interface.
Shows the format for writing set values to the unit via RS-232C.
Explains how to read set values from the unit via RS-232C.
Lists commands that can be sent from the host to control unit functions.
Guides the user through setting the D/A zero and full scale values for analog output.
Explains how to use the unit with a DC power supply and its input voltage.
Explains how to perform the self-check function to detect internal errors.
Describes the procedure to reset all set values to factory defaults.
To Next Page
