4.CALIBRATION
28
・Setting of Scale Division（omissible if no change is needed）
・Zero Calibration
1) Select setting mode 3.
2) Set the scale division.
Use and keys to set the scale division，
then use key to validate the setting.
To return to the indicated value display, press key.
FNC
SEL SEL
DOWN
ENT
Press twice.
UP
DOWN
SEL
ENT
ESC
Setting of Scale Division
Scale Division（001to 100）
1)Check that the sensor is unloaded, then press keys in
this order.
If the indicated value following the display CAL2E is
zero, the zero calibration is terminated.
ENT
and
ZERO
Zero Calibration
To Next Page
Loading...
