Teac MT-20D-IO - Page 120

4-3 Check and adjustment procedures
4-3-1 Positional adjustment of reel motor (F), (R) ASs'y
(1) Articles to be used
(a) Phillips screwdriver (No. 0)
(b) Tweezers
(c) Reel motor jig
(2) Adjustment procedure
(a) Push in the ejector with the finger to bring about the cassette
loading status (Fig. 302, 303).
(b) Loosen the two mounting screws each of the reel motor (F), (R)
Ass'y until the reel motor can be moved easily (Fig. 415).
(c) Set the reel motor jig. While pushing the loading arm in the
arrow direction. put the reel motor jig on the MTU body with the
guide pins as reference. and return the arm gradually. In this
case. check if the reference plane touches the two guide pins
(Fig. 415).
(d) Move the reel motor to the position.
Where the reel hub stopper can be moved up and down smoothly while
pushing it by the tweezers.
(e) Tighten the two mounting screws each of the reel motor with the
specified torque.
(f) Detach the reel motor jig in the reverse procedure to step (c).
(g) Push the eject button to return the cassette unloading status.
- 4027 -