Things to Note
1. The Tango in the RTF set comes pre-installed with a limiter in both beginner and intermediate
mode to assist with getting used to the power and speed of a racing drone. Beginner mode is
limited to 60% of the throttle curve, intermediate mode is limited to 80% of the throttle curve. To
remove this limitation, simply create a new “DRONE” in the Tango screen using the FC type
“Betaflight” (all other options left default).
2. You can switch the propeller rotation direction to achieve better performance of your drone. You
can do this by reversing the motor direction in Betaflight, reversing all ESC directions in BLHeli
Suite and also changing the propellers for each motor to match. The benefits are less likelihood of
shoving debris onto your lens, and a slightly increased cornering ability as well as top speed.
3. You can zip tie the XT60 connector cable to one of the rear arms in order to protect the internal
PCB from getting pads ripped out in hard crashes.
To Next Page