Why does my Team Losi Motorized Toy Car have poor range and/or glitching?
If your Team Losi Motorized Toy Car experiences poor range or glitching, first, check and replace the transmitter batteries. If the issue persists, recharge the vehicle's battery. Lastly, examine all wire connections and plugs to ensure they are secure.
Why does my Team Losi Motorized Toy Car have poor run time and/or sluggish acceleration?
If your Team Losi Motorized Toy Car has poor run time or sluggish acceleration, try these steps: ensure the battery pack is fully charged by recharging it. If the problem continues, try using another charger. Also, check the wheels and transmission for any binding issues.
How to fix a Team Losi Motorized Toy Car that does not operate?
If your Team Losi Motorized Toy Car does not operate, ensure the battery is charged and plugged in, and that the ESC switch is turned “On”. Also, check that the transmitter is turned “On” and that the batteries are not low; replace them if necessary.
Why is the steering not working on my Team Losi Motorized Toy Car?
If the steering on your Team Losi Motorized Toy Car isn't working, first check that the steering servo plug is correctly connected to the receiver steering channel, paying attention to the correct polarity. If it is connected properly, the servo gears or motor may be damaged, requiring you to replace or repair the servo.
What to do if the motor runs but the wheels don't rotate on my Team Losi Motorized Toy Car?
If the motor runs but the wheels of your Team Losi Motorized Toy Car do not rotate, check the following: Adjust the pinion/spur mesh if they are not meshing properly. Tighten the pinion gear setscrew on the motor shaft flat spot if the pinion is spinning. Replace the transmission gears if they are stripped. Check and replace the drive pin if it is broken.
General| Brand | Team Losi |
|---|---|
| Model | BAJA REY |
| Category | Motorized Toy Car |
| Language | English |
General safety guidelines and operational advice for using the vehicle in various conditions.
Procedures for maintaining the vehicle after operation in wet environments to prevent corrosion.
Steps to calibrate the AVC receiver to the transmitter for proper operation.
Instructions for properly installing AA batteries into the transmitter.
Procedure to calibrate the ESC to the transmitter inputs for optimal performance.
Information on adjusting pinion and spur gears for optimal performance and temperature.
Guidance on how to obtain warranty support and service for the product.
To Next Page