To Next PageTo Next Page
Need help?Do you have a question about the Team Losi EIGHT and is the answer not in the manual?
General| Brand | Team Losi |
|---|---|
| Model | EIGHT |
| Category | Motorized Toy Car |
| Language | English |
Sophisticated hobby product, not a toy, requires adult supervision and basic mechanical ability.
Not for children under 14 years.
User responsibility, radio interference, general safety practices for operation.
Vehicle is water-resistant, not waterproof; maintenance for wet conditions is crucial.
Battery compatibility, transmitter safety, avoiding saltwater, engine temperature, and wet condition strain.
Remove batteries, dry contacts, blow out water, rinse tires, air dry vehicle.
Warnings about improper use, fire risk, and safe charging practices.
Procedure for charging the NiMH receiver battery pack.
Identifies transmitter controls and installing transmitter batteries.
Operational safety, maintaining sight, inspecting hardware, and engine cooling.
Fuel handling, storage, and engine operation safety guidelines.
Explanation of rich/lean mixtures and carburetor adjustment effects.
Sequence for starting the engine: transmitter, receiver, glow igniter, pull starter.
Critical for performance and engine life; failure causes damage. Use specified fuel.
Run rich, ease throttle, figure-8 pattern to get a feel for steering and handling.
Tune for optimum performance, avoid overheating, make adjustments in one-hour increments.
Checks before adjustment, factory needle settings, and carb adjustments.
Adjusts fuel mixture for optimal acceleration and steady rate.
Affects idle and slightly-off-idle performance; adjust idle speed and mixture.
How to measure engine temperature and what the readings indicate.
Steps to turn off the vehicle: remove body, pinch fuel line, power off receiver, then transmitter.
Common issues and solutions for engine start, stalling, movement, and control.
Steps to rebind the transmitter and receiver, including a notice about interference.
Procedure to test the glow plug and igniter, and how to clear a wet glow plug.
Procedures for service, inspection, and submission with RMA.
