Not Included
AA
1
Tramsmitter Function
2
Operating Procedure
01
02
Install 8pcs AA batteries to the H.A.R.D. transmitter.
Insert the antenna wire into the tube as shown.
Fasten the tube with a set screw and put on the
tube cap.
03
Thumb nuts are used to fasten the battery
holder. Use appropriate charger to charge
the included receiver battery pack.
04
Turn on the transmitter first.
05 06
Connect the battery pack to the speed controller. Finally, switch on
the speed controller power.
H.A.R.D. Dual Mode Speed Controller is the most advanced speed
controller at the market. There are two modes available: Gentle &
Fierce.
Gentle Mode: Yellow Indication Light (50% output)
Fierce Mode: Red Indication Light (100% output)
After switch on, the speed controller will auto-reset the throttle
neutral position within 5 seconds with beep sound. Push the button
for 3 seconds on the speed controller to switch the mode.
Rotate the transmitter wheel for left and right.
Pull the trigger for acceleration and push the trigger for brake and
reverse.
Switch
Mode Switch Button
Switch
LED Light
Red 100%
Yellow 50%
!
Notice there is
a small space for
wire to go through.
!
Optional The cushion
foam usage depends
on the battery type.
Steering Wheel
Tum model to left or right
Throttle Trigger
Control the speed of the
model and movement
forward and backward
Steering Trim
Adjusts the steering in small
increments so the model will
run straight.
Battery Level
Indicator
If the Red led flashes , replace
batteries.
Power Switch
When slid upward,the power
is turned on.
TH Servo
Reversing Switch
ST Servo
Reversing Switch
Throttle Trim
Adjusts the throttle in small
increments so the model will
not move at neutral
Antenna
Instruction & Setup Manual
To Next Page
Need help?
General
