Team Play Fun Stop Photos Gen II User Manual (English)

To Next Page

Page 1 of 10

PRINTER'MEDIA'INSTALLATION'

NOTE:''CHANGE'YOUR'PAPER'AND'INK'ROLL'AT'THE'SAME'TIME.''The$media$kit$always$comes$

with$ excess$ paper,$ which$ is$ intended$ to$ be$ thrown$ away$ or$ wasted$ during$ printer$

calibration.$$We$ recommend$ that$ if$ your$ photo$ booth$ says$ “No$ Paper,”$ you$ should$

change$both$the$paper$and$the$ink$ribbon.$$'

NOTE:'TORN'INK'RIBBON'DOES'NOT'HAVE'TO'BE'REPLACED.''In$the$unlikely$event$that$an$ink$

ribbon$ tears$ because$ of$ a$ paper$ jam$ (such$ as$ a$ popsicle$ stick$ pushed$ into$ the$ printer$

paper$ outlet),$the$ ribbon$ does$ not$ have$ to$ be$ replaced.$ $ The$ ink$ ribbon$ can$ be$ taped$

together$and$advanced$past$the$repair.$

You will find this sticker inside the coin door at the rear of your photo booth:

Other manuals for Team Play Fun Stop Photos Gen II

Need help?

Do you have a question about the Team Play Fun Stop Photos Gen II and is the answer not in the manual?

General

Detailed steps for installing the print paper roll and its components, including spacers.

Instructions for correctly loading the ink ribbon and ink cassette into the printer.

Procedures for safely removing media components before transporting the unit.

Warning regarding handling paper during operation to prevent errors or quality degradation.