Plug the power cord into the outlet and press the ON / OFF. The buzzer will
sound twice and the unit is now in standby mode. Only ON / OFF button is
active.
To start the appliance press again the ON / OFF button.
The device starts in "Normal Mode" with medium fan speed and goes down
to low speed after 3 seconds.
Press the ON / OFF again to turn off the unit, the beeper will sound once.
Used to select fan speed or fan program.
Press repeatedly to cycle through the different modes.
Normal Mode
Chose speed between: Low Medium High
Natural Mode
The unit automatically switches between the three speeds at 5 second
intervals. Horizontal oscillation starts immediately and vertical start after
10 sec.
Sleep Mode
The unit automatically switches between the three speeds with 30 second
intervals. Works in together with timer function 8H
Repeatedly press this button to set the desired time. (1 to 8 h) An indicator
lamp shows the selected time. The countdown begins now. The timer
function needs to be activated when the unit has been turned off.
Horizontal
Press this button to start the horizontal swing function. LED indicator
lights.
Press again to exit the function. The indicator goes off.
Vertical
Flaps open completely (135 °) when the unit starts.
Press this button to start the vertical swing function. LED indicator lights.
The air stream will swing between 70 ° -135 °.
Press the button again to stop the flaps at any angle between 70° -135°.
The flaps will close when the unit is turned off.
This button starts the cooling and humidifier function. The buzzer sounds
once and the LED indicator lights up.
Turn off the function by pressing this button again.
NOTE! Make sure the water level in the tank is above the minimum mark in
order not to damage the water pump
The water pump will run for 50 sec. If the water level is too low, the
function will stop and the buzzer sounds to attract attention.
Fill the water tank.
The device will stop working after 100 hours of work and the "Clean Filter"
indicator lights up. Clean the filter according to the instructions and press
the "Cooler / Humidifier" for 5 sec. to reset the “Clean Filter” warning.
The device is now back to normal status.
The indicator dims down after 1 min. without any action, but lights up
when a button is pressed.
To Next Page
Loading...