GUIDE TO CONTROLS
The GED-2112 Geddy Lee Signature SansAmp rackmount introduced a new
format for Parallel Pre-Amping --having two separate internal pre-amps that
run in parallel. Following this concept, the SansAmp YYZ pedal adapts the
architectural structure to simplify blending the two signal paths via its own
Mix control.
DRIVE SECTION
DRIVE
Adjusts the overall amount of gain and overdrive, similar to when the output
section of a tube amp is being pushed. Also controls the input sensitivity with
clean sounds. For fatter, more robust clean sounds, increase Drive until it
starts to distort, then gradually decrease until it disappears.
HIGH and LOW
These active tone controls cut or boost
±
12dB from unity gain at 12 o’clock.
High is 3.2kHz. Low is 80 Hz.
MID
2kHz @ 20dB boost
1kHz @ 10dB cut
TIGHT BUTTON
Adds definition to your notes in cleaner settings and make distorted tones
snappier.
MIX SECTION
MIX
Blends the ratio of high-end studio clean (Deep) and dirty bass tube amp tones
(Drive).
The Deep side offers thick, meaty tones, with a preset EQ curve custom tai-
lored to Geddy’s personal specs.
The Drive side is based upon the GED-2112 Geddy Lee Signature SansAmp
rackmount, for a wide range of sonic possibilities.
MASTER
Controls the overall volume. Adjusts the output level without altering any of
the tonal characteristics.
For recording applications, we recommend setting at least halfway
(12 o’clock).
For best results with an amplifier, the output level of the SansAmp
YYZ should be close or equal to the signal in bypass. Otherwise, it could over-
load the input of the amp and result in undesirable, ratty distortion. (Don’t say
we didn’t warn you!)
PLACEMENT ORDER OF OTHER EFFECTS
For best results, plug your instrument directly into the SansAmp YYZ. This will
preserve the interactive nature of the unit. When incorporating into a pedal-
board, we suggest experimenting to find the order that’s best for you. As a
general guide, we recommend:
Place the following effects BEFORE the SansAmp YYZ:
Compressor, Envelope Filter/Follower, Fuzz Box, Pre-Amp, Wah-Wah.
Place the following effects AFTER the SansAmp YYZ:
Chorus, Delay, EQ, Pitch Shifter, Reverb.
5 6
To Next Page
Loading...
Need help?
General
