To Next PageTo Next Page
Need help?Do you have a question about the techem Vario 4 and is the answer not in the manual?
General| Power source | Battery |
|---|---|
| Radio frequency | 868 MHz |
| Battery life | 10 years |
| Mounting | Radiator |
| Power supply | Lithium battery |
| Type | Electronic heat cost allocator |
Explains the meter's function as an energy meter for heat and cold measurement in heating systems.
Outlines essential safety regulations for using energy meters and pressure equipment, including earthing and cleaning.
Explains the choice between inlet or outlet installation for the volume measuring section, valid during commissioning.
Details environmental requirements for installation and specified operating/storage conditions and radio frequency.
Provides general installation guidance, emphasizing environmental observation, avoiding work near the meter, and system installation.
Details suitable/unsuitable installation sites and recommended orientations for optimal meter performance.
Ensures correct sensor type matching and short cable management for optimal performance with temperature sensors.
Lists and explains various error codes (C-1, E-1 to E-5) displayed by the meter and their corresponding meanings.
Explains error codes E-6 (incorrect flow direction) and E-7 (no ultrasonic signal) and their common causes.
Provides a checklist for common heat meter issues and specific steps to resolve error E6.
Details metrological configuration options including energy unit, installation location, and ending configuration.
Provides a procedure to set the installation location (outlet/inlet) via the 'Metrological configuration' menu.
