TechMatte amFilm User Manual

Begin by cleaning the screen with the Wet
Wipes and the Microfiber Cleaning Cloth.
Using your index finger, swipe down the
middle of the screen, making the protector
begin to adhere to the phone. At this step, only
the middle of the protector will be attached to
the phone.
Remove the installation tray from the phone.
On the right-hand side of the phone, take the
squeegee and FIRMLY push from bottom to
top, pushing the air out of the TOP of the
phone.
Remove any case from the phone. Place
the Easy Installation Tray on the phone,
aligning the top of the tray with the top of
the phone.
Peel off the mask film to expose the
adhesive surface of the screen protector.
Using the Easy Installation Tray as an
alignment guide, line up the top or bottom
of the protector and carefully place the
protector on the phone.
FIRMLY repeat on the left side of the phone,
directing air to come out of the TOP of the
phone.
If there are any bubbles, lift the NEAREST
corner to the bubble, and re-squeegee that
area. Repeat until all bubbles are gone.

TechMatte amFilm Specifications

General

Brand	TechMatte
Model	amFilm
Category	Cell Phone Accessories
Language	English

Summary

Screen Protector Installation Guide

Clean the Screen

Clean the phone screen using the provided wet wipes and microfiber cleaning cloth.

Position Installation Tray

Place the Easy Installation Tray onto the phone, aligning its top with the phone's top edge.

Expose Adhesive Surface

Peel off the mask film to expose the adhesive surface of the screen protector.

Align and Place Protector

Use the tray as an alignment guide, line up the protector, and carefully place it on the phone.

Adhere Protector Center

Use your finger to swipe down the middle of the screen, adhering the protector to the phone.

Remove Installation Tray

Once the protector is partially adhered, remove the installation tray from the phone.

Squeegee Air from Sides

Firmly push from bottom to top on both the right and left sides to expel air.

Address Remaining Bubbles

Lift the corner nearest to any bubbles and re-squeegee the area until all bubbles are gone.

Support and Warranty Information

Warranty Claims

Initiate a 1-Click Warranty Claim or register for lifetime warranty coverage.

Customer Support and Website

Contact customer support via email or visit the official website for assistance and resources.