D.2
Put the head back on the basis
tighten the screw 2
E.1
Loosen the screw 1 (little by little)
turn the device to the right position
(max. 360° around)
tighten the screw 1
E.2
Loosen the screw 2 (little by little)
bend the device to the right
postion (max. 180°)
tighten the screw 2
Mode Light
Light Mode
Note: Use only new alkaline D-Cell
batteries with 1.5V rating. Do not mix
old and new batteries. Install
batteries with polarity in correct
position
To Next Page
Loading...