3
Use of the device
→ Charging
Before first use, connect the USB port of the charging cable to the
TX-112. Then connect the USB port of the charging cable to the
USB port of an AC adapter* (*not included) or to the USB port of a
computer. During charging the yellow LED is flashing. When it is
fully charged, yellow LED will steady on.
Note: the camera is provided with the built-in hi-capacity lithium
battery. The battery has no memory effect and can be charged at
anytime, but it has to be charged fully after having been used up for
the first five times of charging so as to activate the maximum
capacity of the battery and obtain the standard operating time.
→ Internal storage
Since the TX-112 uses a built-in memory card (MicroSD), it is not
recommended to remove or replace other memory cards.
→ Before Operating video, audio, photo or data transfer
Note: If you’d want to take videos on powering on, please check
whether the change-over switch is on video status. For each power
on, the unit enters into the initialization state. During the process of
initialization, the system is busy, please don’t operate other
functions. If press the button repeatedly, or connect the unit with a
computer. The time of initialization is a little different in the units
with different memories.
→ Audio and Photo recording
Start Audio recording
Set operation switch to position 1, long press power key, blue LED
will turn on. Yellow LED flashes 2 times and TX-112 starts audio
recording automatically. Short press power key again, the audio will
be saved and TX-112 will go into standby mode.
To record a new audio long press the power key again. The yellow
LED flashes 2 times and turns off. A new audio recording starts.
Take a photo
You only can take a photo, when you have done an audio recording
before. Then short press the button once after saving the audio file.
To Next Page
Loading...