7
Password Protection: [On] / [Off] (default). Select and press OK button to
confirm.
Set the power-on password of the camera. The password is four digits, each
digit ranges from 0 to 9. Attention: If you set the password, write it down to
make sure that you do not forget it!
Beep Sound: [On] / [Off] (default). Select and press OK button to confirm.
Open den Beep sound menu to turn On or Off the confirmation sound of the
buttons.
Format Memory Card: [Yes] / [No] (default). Select and press OK button to
confirm.
Attention: Formatting the memory card (FAT 32) will delete all data
permanently. Before using a new memory card or a card that has been used in
another device previously, please format the memory card.
Serial No.: [On] / [Off] (default). Select and press OK button to confirm.
Set the unique serial number for the camera. The number is four digits, each
digit ranges from 0 to 9.
Reset Settings: [On] / [Off] (default). Select and press OK button to
confirm.
Restore the camera to factory default settings including password, serial
number and so on.
Version: Look up the Firmware information of the camera.
Take Photos, Record Video, Playback: Switch the Mode Button to “Test”. In
this mode, you can take photos, record video and playback files manually.
Take Photos: Press Capture button to switch to photo mode. Press Shot
button to take a picture.
Record Video: Press Video button to switch to video mode. Press Shot
button to start to record a video clip. Press Shot button again to stop
recording.
Playback: Press Playback button (10) to enter the playback interface.
Press Up/Down button to scroll through photos or videos. When you want to
playback video, press OK button to play the video. Press OK button again to
have a pause. Press Menu button to stop playback. Press Playback button (10)
again to exit the playback mode. Under “Playback” press the Menu button
To Next Page
Loading...
Need help?
General
Weight and Dimensions
