First use
Connect the soundbar with the power adapter cable (11) and a
socket. Connect the included antenna with the antenna interface
(14) and place the antenna near a window, a spot with low
radiation of other electric devices to avoid signal distortion.
Press and hold the power button (6) for three seconds. The
soundbar starts up in DAB mode. Now it searches for DAB
stations automatically. You can also use the soundbar with
Bluetooth, AUX-In, USB stick, optical in or HDMI ARC. With the
mode button (7) you can change the mode from Bluetooth to
AUX, USB, FM/DAB+-radio, optical in or HDMI ARC.
Modes
Switch through the modes by press the mode button (7) on the
soundbar or the mode button on the remote control (2).
Bluetooth Mode
The speaker must be powered on before you begin to initiate the
pairing. Pairing is the process of establishing a link between
TX-139 and a Bluetooth device.
Note: Activate the Bluetooth feature on the phone, and set the
phone to search for Bluetooth devices. Check the user guide of
your phone for instructions.
Select the soundbar „Technaxx TX-139“ from the list of found
devices. When asked the PIN code, please enter “0000” to pair
the speaker to your phone.
If the pairing is successful, you will hear a connection sound and
the speaker enters idle state.
Auto reconnection
When the TX-139 is in off state, switch it on and it will reconnect
automatically to the last connected device if it is reachable.
To Next Page
Loading...
Need help?
General