USB mode
Plug in a USB stick with max. 64GB (formatted in exFAT/FAT32).
Switch to USB mode. Now you can play the tracks one by one.
Note: No folder selection possible.
AUX-Mode
You can play music directly from a device connected via an AUX
cable. Plug one end of 3.5mm AUX–IN cable into AUX–IN
connector (9) and the other end into AUX-OUT (Headphone jack)
connector of MP3 Player, Smartphone, PC or CD player to listen
to music.
Press the mode button (7) briefly several times to switch to AUX-
IN mode. To adjust the volume, press the volume down and
volume up buttons on the external device and on the TX-139.
Note: Under AUX-mode, only vol–/vol+ work. By pressing
play/pause you can mute the device but the song plays along,
because it is coming from an external device. Switch songs on
the external device in AUX-mode.
Radio mode (DAB+ / FM)
Connect the included antenna with the soundbar to receive
DAB+ and FM radio signal. Place the antenna near a window, a
spot with low radiation of other electric devices to avoid signal
distortion. Screw the male connector to the SMA connector (14)
on the soundbar.
Briefly press the mode button (7) until you switch to Radio mode.
You can choose between digital radio (DAB+) and FM radio (FM).
The automatic station searches and the automatically storage of
the found stations can be started by press and hold the
play/pause button (4) or press on scan (12) at the remote control.
Press the next track or previous track button to switch between
the stored stations. Press the play/pause button to confirm a
station. Adjust the volume by press and hold the volume down
(3) and volume up button (5).
Note: Radio stations are saved and stored in the found order. It
is not possible to change the order of the found radio stations or
set favourites.
To Next Page
Loading...
Need help?
General