Technibel GRFMX366R5I - Connection between Indoor and Outdoor Units

Free Match D.C.inverter Muti-variable Air Conditioner Outdoor Unit
6
42K
76
45099
1015
1103
1087
191631
440
401
362
121
Fig. 5
2) During the transportation of the outdoor unit, two lifting ropes long enough must be used in
four directions and the separation included angle must be less than 40°prevent the center
of unit deviating.
3) During the installation, M12 screws should be used to x the support leg and base frame of
the unit.
4) The unit should be installed on a concrete base frame with a height of 10cm.
5) The installation space of the unit should be as required in Fig.6.
Installation Space Requirements of the Outdoor Unit: 36K
42K
Fig.6
2.3 Connection between Indoor and Outdoor Units
(1) Wiring of the Power Cord
CAUTION!
A breaker must be installed, capable of cutting off the power supply for the whole system.
1) Open the side plate.
2) Let the power cord go through the rubber ring.
3) Connect the power card to the terminals “L”, “N” and also the earthing bolt, and then
connect the wiring terminals “N(1),2,3” of the indoor unit to those of the outdoor unit
correspondingly.
4) Fix the power cord with wire clips.