144
6.3 ADVANCED DISPLAY & SETTINGS – CONNECTION TO A3 BOARD
6.3.1 REMOTE CONTROL CONNECTION
Maintenance remote control must be connected to A3 control board by means of an interface ACC-CR-RCS. Connection on A3
board is made on specific connector RC-P (5 poles, colour red).
6.3.2 CURRENT DISPLAY
Note:
It is possible to display current information by means of temperature setting buttons
and to select the item code.
Item code Parameter Remark
10
Total compressor operating time See detail after
16
Total power ON time of the unit
17
Compressor starts counter
FE
A3 board firmware version
FF
A3 board software version
Display when remote control is connected
Current display - Example
Item code “FF” – software version
Software version
To Next Page
Loading...
