Technibike E-CITY - Page 4

4
Once the brake levers are in a position which
suits you, rst tighten the top screw
1
of the clam
bracket of the brake lever to 4 Nm. Then
tighten the lower screw
2
to 4 Nm as well.
Top
1
2
The distance to the handlebars can be adjusted
with an adjusting screw (in the levers) so that the
brake levers can be safely operated by hands of
di󰀨ering sizes.
Adjusting screw
Inserting the Battery
The operating instructions of the
drive system from Continental are
enclosed with your Pedelec. To in-
sert the battery, follow the instructions in this
manual.
Testing
Perform the following test before the
rst ride: Lift your Pedelec up slight-
ly and drop it onto the ground from
about 10 cm in the air. If you hear rattling or
other unusual noises, check all bolted con-
nections. If rattling or unusual noises persist
even after you have checked, have a spe-
cialist dealer or service partner determine
and remove the cause before you set o󰀨.
Now perform the check from the section “Before
your rst ride” in the original operating instruc-
tions.
Legal information
TechniBike GmbH
Julius-Saxler-Straße 3, TechniPark
D-54550 Daun / Germany
Fax +49 6592 712 8219
Contact: info@technibike.de
Website: www.technibike.de
Management: Peter Lepper,
Marc A. Prüm, Claudia Thelen
Responsible for distributing and market-
ing the operating instructions
inMotion mar.com, Rosensteinstr. 22,
D-70191 Stuttgart / Germany
Tel. +49 711 35164091, Fax +49 711
35164099
info@inmotionmar.com, www.inmotionmar.com
Content and images
Veidt-Anleitungen, Friedrich-Ebert-Straße 32
D-65239 Hochheim/Germany
Veidt-Anleitungen@email.de
Legal inspection by a lawyer’s o󰀩ce special-
ising in intellectual property.
This operating manual covers the require-
ments and scope of ISO 4210:2014 and
EN 15194.
In case of delivery and use outside this
scope, the manufacturer of the vehicle must
supply the requisite manuals.
© Before reproducing, reprinting, translat-
ing or using this document for any economic
purpose (even in part, printed or electronic
form), you must rst receive written consent.
TechniBike Installation Version 1.0 January 2018