Typical EQ5300 Input and Output Connections
In the typical setup, a user should wire from the output of the signal source directly to one of the RCA
inputs on the rear of the EQ5300. Once the input signal source is connected to the EQ5300, connect
the amplifier to the EQ5300’s LINE outputs. Pictured above is a TV and DVD player connected to the
EQ5300’s inputs. The REC output is connected to the input of a tape recorder. The LINE output of
EQ5300 is connected to the input of another amplifier. You can bypass the tape recorder and just
connect the LINEOUTPUT to the input of another amplifier. The LINE OUTPUT will send the signal
from the selected input (AUX,DVD,Tape,Tuner
or MP3 Player).
NOTE:WHEN MAKING THESE CONNECTIONS THE POWER OF THE E5300 AND THE SIGNAL
SOURCE SHOULD ALL BE IN THE OFF POSITION
EQ5300
Aduio Input
Power Outlet
(AUDIO OUTPUT)
TV
(AUDIO OUTPUT)
o
(AUDIO INPUT)
To Next Page
Loading...
Need help?
General