Need help?Do you have a question about the Technical Pro EQ5400 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Bands | 10 |
| Type | Graphic Equalizer |
| Bands | 10 |
| Frequency Response | 20Hz - 20kHz |
| Input Impedance | 10k Ohms |
| Output Impedance | 600 Ohms |
| Signal to Noise Ratio | > 90dB |
| Dimensions | 19" x 1.75" x 7.5" |
Button to switch among all input modes. Default is TAPE input.
Button to power the unit on and off.
Button to select spectrum display mode.
Button to switch screen display modes.
Button to increase signal by ±6dB or ±12dB. Default is ±6dB.
Knob to adjust treble on the main output.
Button to disable or activate EQ effect. Changes signal based on slider positions.
Knob to adjust bass on the main output.
Button to power the LEDs of the sliders on and off.
Knob to adjust volume level on the main output.
Sliders to adjust frequencies (30Hz-16KHz) by ±12dB.
Use power cord to provide unit with power. Ensure unit is off before connecting.
Select between 230V AC 50Hz / 115V AC 65Hz.
Connect to recording device or amplifier. Passive output, not for passive speakers.
Connect to recording device or amplifier. Passive output, not for passive speakers.
Connect stereo signal for tuner input. Select Tuner input on front panel.
Connect stereo signal for VCD/CD input. Select DVD input on front panel.
Connect stereo signal for tape input. Select Tape input on front panel.
Connect DVD, mixer, or other 2 Channel sources via RCA jacks. Ensure correct polarity.
Connect active speakers via speaker wire outputs. REC output is passive.
To Next Page