Connecting broadband | Single Socket
If you are using a house phone, connect this into the phone socket on the microlter.
Connect the microlter into the master telephone socket (this should say Openreach on it) unless built in (Diagram
G on page 4 and 4)
Connect one end of the grey DSL cable into the microlter. Connect the other end of the cable into the grey port (DSL) on
the back of your router.
Next, plug the power cable into your electricity supply, connect the other end into the round power socket on
the back of your router.
Switch on your router by pressing the black on/o button located on the back of the router. The power light will
turn orange, after a few minutes this will turn solid green. Please allow 10 minutes for the router to fully power up,
and all lights turn solid green or ashing green.
1
2
3
4
5
7
To Next Page
Loading...
